Detailed Assembly Instruction | How to build the Bizzoelife 47” Gaming Desk?

The following is the whole installation process of the Bizzoelife 47" gaming desk.

Before all the assembly processes, please make sure that you have all the accessories to ensure that your assembly process goes smoothly.

And here is the whole accessories list for your reference.

Parts list

Screw & Tools

If you are not sure what these screws and tools look like, you can refer to the following figure:

Detailed assembly process:

Step 1: Assembling cross bar & leg frame

According to the illustration, install the cross bar (④) to the table legs (①②) with screw A.

In this step, you will use 4 screws, 2 on each side of the left and right.

The upper and lower sides of the cross bar (④) are different, please pay attention to the direction of the cross bar (④).

Step 2: Assembling tie rod & cross bar & leg frame

According to the illustration, connect the tie rod (⑤⑥) and table legs (①②) with screw A.

In this step, you will use 8 screws, 4 on each side of the left and right.

Step 3: Assembling metal tube & leg frame

According to the illustration, put the round tube (③) into the card slot position of the leg frames (①②) to connect the port of the leg frames (①②) and the USB cable (D).

Step 4: Assembling desktop panel & cable grommet

According to the illustration, install the desktop panel (⑦) to the metal frame which has finished by the last step with screw B.

Install the cable grommet (C) to the hole of the desktop panel (⑦).

In this step, you will use 6 screws and 2 cable grommets.

The whole installation process is only four steps, and if all goes well, the event from start to finish is less than 10 minutes.

There is no problem installing it for one person, and it may be faster and easier for two people to install it together.

If there are any questions or missing parts, please contact our customer service support@bizzoelife.com first or leave a message in the comments area below.